Technical Parameters - YATO YT-82044 Manual De Instrucciones

PROPERTIES OF THE TOOL
The manual hammer drill is an ordinary electric tool, insulation Class II, which has been designed for drilling in distinct materials:
metal, wood and wooden products, plastics, concrete, walls, etc. using drills adequate for the material with a cylindrical chuck.
The hammer drill permits continuous adjustments of rotation of the spindle, changing of the direction of rotation, hammer drilling
and drilling without hammering. It may be also used to screw and remove screws, using the bits available on the market. A correct,
reliable and safe functioning of the grinder depends on its proper use, so:
Before you proceed to operate the grinder, read the manual thoroughly and keep it.
ACCESSORIES
The package provided by the manufacturer should contain:
- hammer drill
- additional handle
- drilling depth limiting device
Attention! The tool is supplied without drills!

TECHNICAL PARAMETERS

Parameter
Catalogue number
Nominal voltage
Nominal frequency
Nominal power
Nominal rotation
Maximum hole diameter (steel)
Mass
Level of noise
Acoustic pressure
Acoustic power
Class of insulation
Level of vibration: drilling / hammer drilling
Grade of protection
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
power tool increases the risk of electric shock.
Do not overload the power cable. Do not use the power cord to carry, pull or unplug the power plug from the power outlet.
Avoid contact of the power cable with heat, oils, sharp edges and moving parts. Damage or entanglement of the power cord
increases the risk of electric shock.
In the case of working outside closed rooms, use extension cords intended for work outside closed rooms. The use of an
extension cord adapted for outdoor use reduces the risk of electric shock.
O R I G I N A L
GB
Unit of measurements
[V~]
[Hz]
[W]
[min -1 ]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82044
220 - 240
50
1050
0 - 1100 / 0 - 2800
13
3,5
97,0 ± 3,0
108,0 ± 3,0
II
2,85 ± 1,5 / 10,1 ± 1,5
IP20
11