Handling And Transportation; Checking The Floor Where The Appliance Will Be Placed - Palazzetti ELSA NEW Manual De Instalación Y Mantenimiento

5 HANDLING AND
TRANSPORTATION
The appliance is delivered complete with all the
required parts: metal structure and internal com-
bustion chamber lining installed. These parts
are contained in a packaging suitable for long
distance transportation.
It is advisable to unpack the appliance only when
it has arrived at the installation site.
The product must be handled and un-
packed using suitable means.
Make sure that children do not play with the pack-
aging components (e.g. films and polystyrene):
Danger of suffocation!
During moving, lifting, and unpacking of the
appliance the following is absolutely necessary:
• always keep it upright;
• never tip it over into a horizontal position;
• Removal of the transport pallet
Disposal can be entrusted to a third party, provid-
ed only companies authorised for the recovery
and elimination of the materials in question are
used.
Always follow the regulations in force in the
country in which the appliance is being used for
disposal of materials and possibly for the disposal
report.
To remove the appliance from the transport
pallet:
• Unscrew the side fixing screws.
• Remove the fixing brackets.
• Lift the appliance.
• Remove the transport pallet.
004779040 - 21/03/2022
ITALIANO ENGLISH DEUTSCH
5.1 Transportation
Make sure that the lifting carriage has a
payload higher than the weight of the
appliance to be lifted. The full responsi-
bility of the lifting of loads lies with the
person handling the lifting equipment.
Ensure wood or timber floors are prop-
erly protected in order to prevent the
weight of the appliance from damag-
ing them during movement.
During lifting, avoid jerking or abrupt movements.
Pay attention to overbalancing.
5.2 Checking the floor where the
appliance will be placed
Check the load capacity of the floor slab.
If a floor is not suitable for supporting the
weight of the appliance, install appropriate
steel plates (A - Fig. 7) or concrete base (A - Fig.
8)
equipped with
mesh (B - Fig. 8) to distribute the weight.
For the dimensions of the plates and
the concrete base, use a qualified
technician.
FRANÇAIS ESPAÑOL
Fig. 5
10x10x6 electro-welded
41