Dry Vacuum Operation; Dry Vacuuming - Vacmaster VOM205P Manual Del Usuario

DRY VACUUM OPERATION

2
8 7
8

DRY VACUUMING

WARNING:
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL,
OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO:
COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
CAUTION:
IS A VERY FINE DUST WHICH WILL NOT BE CAPTURED BY THE FILTER AND MAY
CAUSE DAMAGE TO MOTOR.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. In order to prepare your vacuum for dry vacuuming, make sure the reusable cloth filter
completely covers the filter cage against the power head. Your wet/dry vacuum comes with the
reusable cloth filter pre-installed. For installation instructions, see page 13 (Fig. 2 & 3).
3. Place the power head back on the collection tank and secure it in place using the latches (Fig. 4).
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the larger end of the hose into the vacuum port on the collection tank and lock into place.
5. Push the required attachment onto the free end of the hose (Fig. 5).
6. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
outlet. Plug the power cord into the outlet (Fig. 6 & 7).
7. Turn the motor on by flipping the switch to the 'I' ON position and begin vacuuming (Fig. 8).
8. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power
cord from the outlet.
O = OFF I = ON
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
3
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
DO NOT VACUUM DRYWALL DUST, FIREPLACE SOOT, OR ASH. THIS
4 5
9
6