Handook page
34/128
Installation Guide
H/U952T Terminal Transmitter
3.4
2002-11-13/ Rev. A
Wiring Runs
The plastic partition (shaded in the illustration) is scored to facilitate breaking at
convenient intervals.
1
Figure 6. Scored plastic partition for breaking.
1
Use pliers to break off a suitable section.
2
Run the wiring out through the cable duct at the bottom.
3
Use the slots at the opening to secure the wiring with cable straps.
Wiring can be run four ways for connection with other units:
1
3
2
2
Figure 7. Four ways of wiring runs.
• Remove the rectangular covers and run the cabling out through the side (1).
• Break off sections at short side of case and run the cabling downwards (2).
• Run the cabling through the round holes at the bottom of the case (3).
• Remove the circular covers at the top of the side case (4).
2
3
4
5
slots
3
1
TD 92022GB
4
5