jotron WP 900 Manual Del Usuario página 41

Installation Guide
H/U952T Terminal Transmitter
4 Lift off the screw connectors from the circuit board.
Figure 13. Circuit board replacement.
5 Press the four holding clips (1) and release the circuit board as shown (2 and 3), see
figure 13
6 Install the new circuit board in the case, make sure it clicks into the position.
7 Remove the SM/FL module from the old circuit board (if any) and install it on the
new circuit board.
8 Set all switches and jumpers as they were on the old circuit board.
9 Replace the connectors and the antenna coax.
10 Check installation according to the System Installation document.
11 Replace the cover.
2002-11-13/ Rev. A
1
2
1
1
1
on page 10.
3
Handook page
39/128
TD 92022GB
10