How To Use The Saw - Porter Cable 314 Manual De Instrucciones

Ocultar thumbs Ver también para 314:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

not in working order. If telescoping guard
binds or is sluggish, return the saw to your
nearest AUTHORIZED PORTER-CABLE
SERVICE STATION or PORTER-CABLE
SERVICE CENTER FOR REPAIR.
saw firmly to prevent loss of control
which could cause injury. See Fig. 6 for
the proper way to hold this tool.
TO FOLLOW THE LINE OF CUT
A notch is provided on the front edge of
the base to assist in following the line of
cut marked on the workpiece.
The left edge of the notch (A) Fig. 7 is
marked "45". Use this edge to follow
the line when making 45º bevel cuts.
The right edge of the notch is marked
"0". Use this edge to follow the line
when making 90º cuts.
Kickback occurs when the blade is
pinched and the saw is driven backward. Keep your body to the side of the saw.
Stay alert and maintain a firm grip on the saw. Release the switch immediately if
the blade binds or the saw stalls. Keep your blades sharp. Support the panels (Fig.
8). Use a fence or a straight edge guide when ripping. DO NOT force the tool. DO
NOT remove the saw from the workpiece while the blade is moving.

HOW TO USE THE SAW

DO NOT use your saw if
the telescoping guard is
S u p p o r t t h e w o r k
properly and hold the
G u a r d
a g a i n s t
kickback.
12
Fig. 6
A
Fig. 7

Publicidad

Tabla de contenido
loading

Tabla de contenido