Automatic Stopper (As); Memory; Disinfection, Cleaning And Sterilization - Nouvag TCM 3000 Manual De Usuario

TCM 3000

5.5 Automatic Stopper (AS)

The automatic Stopper (AS) is a special function for tightening screws with a precise torque. When the
preset torque level is met, the motor will switch off immediately and the display will show the achieved
torque, for example: [AS
digital display will show again the selected speed.
The values are always shown in Ncm (for example, [AS 20] → the instrument can be loaded with
20 Ncm maximum).
F F F F
The function AS is activated in the reduction 70:1 only, and up to 60 rpm. For other
reduction, multiplication or speed, the devices switches automatically to the AL-
Modus .
Adjusting AS:
1) Press reduction key "70:1".
2) Adjust the speed between 15 and 60 rpm.
3) Press key "ATC SET" . In the display appears the torque selection (for example [AS
4) Press keys "UP" and "DOWN" to select the desired torque values.
5) Press the key "ATC SET" or wait for 5 seconds until the revolutions appear automatically in the
F F F F
display.
If the display says [AL.....] :
Press key "DOWN" until [AS.....] appears in the display.
When the AL-Modus is activated, the green light on the "ATC SET" illuminates.

5.6 Memory

The display will show the speed and torque selection that were last used. All settings are saved in
memory even when the unit is unplugged.

6 Disinfection, Cleaning and Sterilization

Please pay attention to the following important points for the maintenance of the material:
•
Clean, disinfect and sterilize the device and components after each use!!
•
Do not use dissolving agents for cleaning
•
Autoclave material in transparent packaging!
•
Do not fill the sterilization bag more than 80%.
•
Autoclave material at maximum 134° C.
•
Sterilized material should be stored and tagged with sterilization date!
6
All manuals and user guides at all-guides.com
30]. To restart the motor press the key motor or release the pedal. The
NOUVAG AG
20]).
No. 31891 31/05