Operation With „On / Off"-Footswitch; Operation With Vario-Pedal; Automatic Limiter (Al) - Nouvag TCM 3000 Manual De Usuario

NOUVAG AG
5.2 Operation with „On / Off"-Footswitch
The TCM 3000 can be operated with the „On / Off"-Footswitch. The pedal can be used to start or to
stop the motor::
Foot plate not pressed ....................motor off
Foot plate fully pressed:..................motor on
The speed of the instrument will be as the speed selected on the control unit.
F F F F
The delivery of the „On / Off"-Footswitch is optional.

5.3 Operation with Vario-pedal

The speed on the TCM 3000 can be regulated with the Vario-Footcontrol. Use the foot plate to operate
the motor and to vary the speed:
Foot plate not pressed...: ................motor off
Foot plate lightly pressed ................motor runs slowly
F F F F
Foot plate fully pressed:..................motor runs with speed as speed selected on the control unit
The shipment of the "Vario" pedal is optional.

5.4 Automatic Limiter (AL)

The Automatic Limiter (AL) limits the torque in the instrument. When the preset torque is met, the
speed drops up to zero revolutions, but the power in the instrument continues.
The values are always shown in Ncm (for example [AL 20] → the instrument can be loaded with
20 Ncm maximum).
Adjusting the AL:
1) Press key "ATC SET". In the display appears the torque torque set mode (for example [AL 20]).
2) To increase the torque level press key "▲" and to decrease the torque level press key "▼".
3) Press key "ATC SET" or wait for 3 seconds, the speed will appear again in the digital display.
F F F F
If the digital display says [AS.....]:
press "▼" until [AL.....] appears in the display.
When the AL-Modus is activated, the green light on the "ATC SET" key does not
illuminate.
No. 31891 31/05
All manuals and user guides at all-guides.com
TCM 3000
5