Maintenance - KNOVA KN SS-18VVS Instrucciones De Uso

OPERATING THE TOOL
INTERIOR CUTTING (FIG. U)
1. Lay out the design on the workpiece (1).
Drill a 1/4 in. (6.4 mm) hole in the workpiece.
2. Lift the blade tension lever (2) and remove the blade (3).
Refer to BLADE REMOVAL AND INSTALLATION.
3. Place the workpiece on the table with the workpiece
hole (4) over the access hole in the table (5).
4. Install the blade (3) through the hole in the workpiece and
press the blade tension lever (2).
5. Follow the process 3-8 under the section
of FREEHAND CUTTING.
6. When finish the cutting, turn the scroll saw OFF,
remove the blade from the blade holders and remove
the workpiece from the table.

MAINTENANCE

WARNING
For your own safety, turn the switch off
and remove the plug from the power source outlet
before maintaining or lubricating your scroll saw.
GENERAL MAINTENANCE
WARNING
Frequently blow out dust and
grit that accumulates in the motor housing
using compressed air.
ALWAYS use safety glasses. Everyday eyeglasses are
NOT safety glasses. Also use face or dust mask if cutting
operation is dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
An occasional coat of paste wax on the work table will allow
the wood being cut to glide smoothly across the work surface.
WARNING
To avoid shock or fire hazard,
if the power lead is worn or cut in any way,
replace it immediately.
LUBRICATION
Ball bearings in the scroll saw are packed with grease at
the factory and require no further lubrication.
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
5
Fig. U
1
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service organizations,
always using identical replacement parts.
FREE WARNING LABEL REPLACEMENT: If your warning
labels become illegible or are missing,
call 01-800- 70-KNOVA (56682) for a free replacement.
13
3
2
4