Technical Characteristics; Necessary Connections; Installation; Usage Location - Fiamma COMPASS dualBoiler Manual De Instrucciones

ENGLISH
3.3.2. COMPASS 3
3.4.

Technical characteristics

The main technical characteristics are fixed on the type plate that is located on the front panel of the
machine.
3.5.

Necessary Connections

The Compass only work with the pressure of the water net. NEVER use this machine with
"jerrycans" or other water supplying equipments that do not guarantee a minimum pressure of 1
bar.
Water entry: 1 water tap prepared for a 3/8 nut
Drain: 1 discharge pipe that can hold a water drain hose with at least 16/17 mm diameter.
Electricity: 1 earthed electric mains supply with a 30mA protection and a circuit breaker with 3 mm
space between the contacts

4. Installation

4.1.

Usage location

Choose a dry location for the coffee machine where it cannot come in direct contact with water.
Do not direct water jets onto the equipment!
Choose a stable and leveled surface to place the machine on.
For a correct installation, that surface the machine is placed on must have a height of at least 800
mm above the floor level.
Keep the machine at a safe distance from inflammable or heat-sensitive materials. If this is not
possible, isolate the space surrounding the machine with a non-inflammable, heat resistant
isolation material.
Always use a water filter system with this machine.
 Leave enough space next to the machine for the water filter system and a grinder.
 The recommended ambient temperature is 15º-25ºC
4.2.

Unpacking

Before using the machine for the first time, remove all plastic protections. Make sure the machine is
complete. Dispose safely of the plastic wrapping as they are potentially dangerous. Clean the exterior of
the machine with a soft humid cloth.
4.3.

Setup of water connection

1. Place the machine in a stable position on the working surface, ideally already in its final position.
Then unfasten the water entry hose already installed in the machine.
2. Place the water filter system in an adequate position and connect it to the water supply.
3. Connect the water filter system/ water purifier to the machine with the water entry hose that was
already installed in the machine. Fasten the water entry hose.
4.4.

Electric installation

IMPORTANT: AN EARTHED CONNECTION IS COMPULSORY. Only connect the machine to an
earthed mains supply!
26
Compass Espresso Coffee Machine by fiamma – Operating Manual
All manuals and user guides at all-guides.com
 Probe 1 – temperature of group 1 (leftmost);
 Probe 2 – temperature of group 2 (center);
 Probe 3 – temperature of group 3 (rightmost)