Operating Instructions; Getting Started - Fiamma COMPASS dualBoiler Manual De Instrucciones

Make sure that the rating on the data plate corresponds to the voltage and frequency of the
power supply.
Make sure the mains electric supply has a 30mA protection and a circuit breaker with 3 mm space
between the contacts.
Do not connect the machine to the mains electricity supply multi-socket adapters or an extension
lead.
All installation works must strictly comply with current local and national safety regulations.
 On the bottom of the machine there is a terminal for the equipotential connection between
different equipments, marked with the symbol

5. Operating Instructions

Never operate the machine with wet hands!
Danger of burning and scalding! The liquids and steam are very hot! Do not approximate your
face and hands to the zone above the steam wands.
Do not touch the groups and the metal parts of the porta-filter because they are very hot!
5.1.

Getting started

5.1.1. FIRST SETUP
First open the water tap, only then use the I/O switch in order to switch the machine on.
 During the first water filling, the heating only initiates AFTER the water has reached the minimum
level (when the green signal light turns off)
 In all other cases, the heating is permanently working, except for when the water level has sunk
below the minimum and the machine is blocked.
1. Open the water tap in order to make sure the machine is supplied with water.
2. Press the main switch on the right front of the machine.
3. The display shows the software version currently installed:
4. After a few seconds, the display shows
 All groups are inactive and all functions of the machine are blocked, except for the technical
programming mode
5. In order to turn on the electronics, press key 3 (ON) on group 1 (leftmost group).
The display shows
6. The green signal lamp (pump) lights up, indicating that the machine has automatically initiated the
water filling of the water/ steam boiler. When the green signal lamp switches off, the orange signal
lamp lights up, indicating that the heating process is in progress.
 It takes about 20 minutes until the water/steam boiler has reached its default working
temperature of 122ºC.
All manuals and user guides at all-guides.com
"OFF".
Compass Espresso Coffee Machine by fiamma – Operating Manual
ENGLISH
27