Programming; Programming Of Coffee Portions; Programming Of Hot Water Portion - Fiamma COMPASS dualBoiler Manual De Instrucciones

7. Programming

 The programming of drink portions, hot water and steam temperature works via simulation.
 All settings programmed on group 1 (leftmost group) are automatically transferred to the other
groups. However, it is possible to program each group separately.
 During the programming of one group, all other groups, as well as the water and steam
production, are blocked.
7.1.

Programming of coffee portions

1. With the machine in ON mode, press key 5 of group 1 (leftmost group) and keep it pressed for 5
seconds. Key 5 starts to blink and the display shows the following message:
2. Within 30 seconds, press the key you want to program, choosing between the 4 keys that
correspond to portions (keys 1-4), for exemple key 1. Pressing the key, drink production starts. Key
5 remains lit during the programming phase.
3. When the desired amount of coffee has been produced, press any of the keys 1-4 on the active
group in order to stop the production. The LED of the programmed key turns off, while all other
keys light up.
4. In order to program the remaining keys, repeat steps 2-3.
7.1.1. TROUBLESHOOTING: PORTION PROGRAMMING DID NOT WORK
In case the programming of a key did not work, please check the following:
- Correct functioning of the water circuit
- Correct functioning of the flowmeter
- Correct association between flowmeter and group
7.2.

Programming of hot water portion

 The saved settings for the hot water keys on group 1 are NOT transferred to the other groups!
1. With the machine in ON mode, press key 5 of group 1 (leftmost group) and keep it pressed for 5
seconds. Key 5 starts to blink and the display shows the following message
All manuals and user guides at all-guides.com
Compass Espresso Coffee Machine by fiamma – Operating Manual
ENGLISH
31