Makita JR3051T Manual De Instrucciones página 6

Attach the hook by following procedure.
1. Insert the tip of slotted screwdriver into the notch
and remove the the cover by pressing and sliding it.
1. Notch 2. Cover
2.
3. Secure the hook with the screws.
1. Square nut 2. Hook 3. Screw
ASSEMBLY
CAUTION:
CAUTION:
Before installing the recipro saw blade, always make
sure that the blade clamp lever (part of the blade clamp
sleeve) is in released position
the blade clamp lever in the direction of the arrow so
that it can be locked at the released position
1. Blade clamp lever 2. Released position
3. Fixed position
Insert the recipro saw blade into the blade clamp as far
recipro saw blade. Make sure that the recipro saw blade
cannot be extracted even though you try to pull it out.
1. Recipro saw blade 2. Blade clamp sleeve
CAUTION:
be extremely dangerous.
To remove the recipro saw blade, rotate the blade
clamp lever in the direction of the arrow fully. The reci-
pro saw blade is removed and the blade clamp lever is
1. Recipro saw blade 2. Blade clamp lever
CAUTION:
If you remove the recipro saw blade without
rotating the blade clamp lever fully, the lever may not be
locked in the released position
the blade clamp lever fully again, then make sure that
the blade clamp lever locked at the released position
If the blade clamp lever is positioned inside
blade out. Unplug the tool before installing or remov-
ing the recipro saw blade.
-
on the insulation
.
This can
.
. In this case, rotate
.
OPERATION
CAUTION:
CAUTION:
shoe is removed or held away from the workpiece
during operation, strong vibration and/or twisting will
be produced, causing the blade to snap dangerously.
CAUTION:
CAUTION:
CAUTION:
cause premature blade wear.
CAUTION:
allow the tool to bounce. Bring the recipro saw blade
into light contact with the workpiece. First, make a pilot
groove using a slower speed. Then use a faster speed
to continue cutting.
Fig.8
NOTICE:
Doing so increases the reaction force which may
break the recipro saw blade.
MAINTENANCE
CAUTION:
NOTICE:
To maintain product SAFETY and RELIABILITY,
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder
1.
caps.
2. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
1. Brush holder cap
6 ENGLISH
If the
Failure to do so will