Uninstalling; Sdisassembly; Back Disassembly - battioni Pagani BALLAST 3500 Manual De Instrucciones De Uso Y Mantenimiento

3.6 UNINSTALLING

The rotary blades vacuum pump must be disinstalled using the following procedure:
... D / M-MA / K-KA
1) stop the PTO of the tractor.
2) remove the cardan shaft
from the power take-
off of the rotary blades
vacuum pump;
3) remove the connection
tube that unites the rotary
blades vacuum pump to
the tank car by loosening
the metal clamp and
sliding the tube from the
sleeve;
4) remove any water or or air
connections;
5) remove the screws and
disassemble the rotary
blades vacuum pump.
3.7 DISASSEMBLY

3.7.1 BACK DISASSEMBLY

BALLAST SERIES 3500-4500-6000-7500-9000-11000-13500
1) Remove the rear cover or oil pump (together with the connecting joint) from the flange;
2) Remove the seeger ring from the rear pin;
3) Remove the screws from the rear flange.
4) Screw two screws into the threaded extraction holes just until the flange can be removed;
1. Close the oil cock placed on the tank
2. Remove the back cover with the lubrication pump (together with the connector joint) from the flange;
3. Remove the screws from the back flange;
4. Use two screws for screwing into the threaded extraction holes until the flange is removed;
.../P
1) stop the PTO of the tractor.
2) remove the drive belts;
3) remove the connection
tube that unites the rotary
blades vacuum pump to
the tank car by loosening
the metal clamp and
sliding the tube from the
sleeve;
4) remove any water or or air
connections;
5) remove the screws and
disassemble the rotary
blades vacuum pump.
BALLAST SERIES 16000
instruction manual BALLAST series
.../C -GA
1) stop the PTO of the tractor.
2) remove the cardan shaft
from the power take-
off of the rotary blades
vacuum pump;
3) remove the connection
tube that unites the rotary
blades vacuum pump to
the tank car by loosening
the metal clamp and
sliding the tube from the
sleeve;
4) remove any water or or air
connections;
5) remove the screws and
disassemble the rotary
blades vacuum pump.
user and maintenance
.../H
1) stop the hydraulic system.
2) remove the hydraulic
connections to the motor.
3) remove the connection
tube that unites the rotary
blades vacuum pump to
the tank car by loosening
the metal clamp and
sliding the tube from the
sleeve;
4) rremove any water or or air
connections;
5) remove the screws and
disassemble the rotary
blades vacuum pump.
p. 41