Changing The Device Name; Configuring The User Mode; Configuring Date And Time Settings - Resol DL2 Plus Manual

7.16.2 Setting up BACnet communication
Note
The BACnet functionality will only be available, if the Modbus functionality
is deactivated.
Note
BACnet uses port 0xBAC0 (47808).
To enable the communication over BACnet / IP in the local network, some adjust-
ments have to be made in the BACnet menu.
In order to setup the BACnet communication, proceed as follows:
1. In the Configuration main menu, select the BACnet submenu.
2. Activate the BACnet functionality.
3. Enter the corresponding number in the BACnet Device Instance ID field.
The BACnet Device Instance ID is assigned by the user or the planner of the
building management system.
The current configuration is shown under Installed configuration.
Î In order to upload a configuration, click on Select and select the desired con-
figuration.
If a matching configuration has been uploaded but not yet installed, it will be indi-
cated under Matching built-in configuration.
Î In order to install a matching built-in configuration, click Apply.
Information about built-in and installed configurations can be downloaded as an
EDE file.
Î In order to download a EDE file containing data points made available, click
Download EDE.

7.17 Changing the device name

Note
Choose a descriptive device name to facilitate identifying the device in
the network.
In order to change the device name, proceed as follows:
1. In the Configuration main menu, select the General submenu.
2. In the General Configuration menu, enter the device name in the Device
name field.
Permitted characters are: letters, numbers, underscores, hyphens.
Special characters are not allowed.
3. Click Save configuration.
7.18 Configuring the user mode
The user mode of the Web interface can be changed from standard user to expert
and vice versa. In the expert mode, additional information and settings are available,
such as: LAN configuration, LAN information, firmware updates, etc.
In order to adjust the user mode, proceed as follows:
1. In the Configuration main menu, select the General submenu.
2. Activate the expert mode in the Expert mode menu item.
3. Click Save configuration.
7.19 Configuring date and time settings
The date and time configuration determines where the device obtains its date and
time information.
The device receives the date and time configuration automatically via the adjust-
able time zone (factory setting UTC). Settings can also be carried out manually.
In order to adjust date and time manually, proceed as follows:
1. In the Configuration main menu, select the Date and time submenu.
2. Tick the Set date / time field.
3. Adjust the date in the date field.
4. Adjust the time in the time field.
5. Click Save configuration.
35