Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operations
Confirm with OK.
Hours and minutes
Confirm with OK.
Use the +/- buttons to set the required values.
Cancel program creation by pressing
MENU button.
Work cycle
Use the +/- buttons to set the OPERATION
CYCLE.
Press the «-» button to activate the program,
press the «+» button to switch over to the next
day.
The scrolling cycle is repeated.
Confirm with OK.
ATTENTION!
If no day of the week is selected, the program will not be created. To cancel adding a program during its setup, press MENU
Action (enable / disable)
Use the +/- buttons to set the additional function
ON or OFF.
Confirm with OK.
ATTENTION!
Inserted programs do not create permanent pairs to turn the contact on and off.
They are perceived as single commands and are executed according to the chronology of a given time. The cases of
overlapping switching times of contacts of two pairs of programs ON-OFF, or single commands are shown in the diagrams:
Prog 1
Prog 2
Contact
ON 1
ON 2
The time of switching on the contacts, set by a pair of programs, can be more than 24 hours, which means that the program.
The ON [ON] can be set for any day of the week (for example Tuesday 13.45), and the program OFF [OFF] for any other day of
the week ( for example Thursday 17.05).
In the menu for setting the channel parameters,
use the +/- buttons to select the edit mode of the
on-off program «Edit».
Confirm with OK.
Select the cell number to edit using the +/-
buttons.
Confirm your selection with the OK button.
Edit in the same way as in paragraph 10.
Prog 1
Prog 2
Contact
ON 1
OFF 1
ON 2
OFF 1
5.3. Editing the on-off program - Edit
Result provides buttons
The time relay switches to setting the
parameters of the single on / off program.
The time relay will go into the mode of setting
the next parameters: hours and minutes.
Lit symbol of the day of the week in the top
line means that the program is active on
that day.
The time relay switches to the program type
setting mode ON [ON] or OFF [OFF].
The time relay will automatically switch to the
recording mode of the next weekly program.
OFF 2
Prog 1
Prog 2
Contact
ON 1
OFF 1
OFF 2
The relay switches to the mode of selecting
the memory cell number. The number of the
first used memory location is automatically
displayed.
The time relay will go on to edit the
parameters of the single on/off program.
9
Prog 1
Prog 2
Contact
ON 1
OFF 1
ON 2
Prog 1
Prog 2
Contact
Display indication
Mo
T
W
T
F
S
S
U
E
H
R
A
U
/
ON 1
OFF 1
OFF 2
Publicidad
Tabla de contenido
