Stand-Alone; Remote Control Operation - NEO STEAM 1500 RGBA Manual De Usuario

5. OPERATION

Stand-alone

Please put the Steam 1500 RGB on a dry and flat
surface.
1. Plug mains power cord from the fog machine
into appropriate power supply socket.
2. Primary power on, LED display (G of figure)
shows "8888", and 26 LEDs (A of figure) around
the nozzle all light up. Please check if the LED
letters shown on the display lack of strips, and
then show the current software version.
3. 2 seconds after it switches to working status:
Heating up, it shows "HEAt". Setting function
value is allowed when heating up. With no op-
eration after 4 seconds, it goes back to "HEAt"
status.
4. Wait about 9 minutes for heating element to
heat up.
5. Push the Manual Fog button (L of figure) to
smoke.
• Manual fogging is available under any con-
trol mode and always executing the Color
Macro of CHA.

Remote Control Operation

For best result, use DZ-2 wireless controller.
1. Firmly attach the remote control to socket (O of
figure) on the back of the unit.
2. Plug mains power cord from the fog machine
into appropriate power supply socket.
3. LED display (G of figure) shows "8888", and 26
LEDs (A of figure) around the nozzle all light
up. Please check if the LED letters shown on the
display lack of strips, and then show the cur-
rent software version.
4. 2 seconds after it switches to working status:
Heating up, it shows "HEAt". Setting function
P. 10
Neo Steam 1500 RGBA - English version
value is allowed when heating up. With no op-
eration after 4 seconds, it goes back to "HEAt"
status.
5. Wait about 9 minutes for heating element to
heat up.
6. Except "dx" and "A.xxx", under any other status,
wireless control is available while DMX control
is not available.
7. Refer to your controller manual for controller
operation details. (Appendix A )
• Manual fogging could be work with remote
control operation at the same time.
• When shot down, the present function status
will be saved automatically and continue
when powered on next time.
Important Remark
When the green LED on the controller lights up, it
does not mean that the machine has got complete-
ly heated, but just means that the machine reaches
an enough temperature for fogging.
Check the red dot in the middle of CH.A (or others
like CH.b etc.) on the LED display to know whether
the machine has completed heating up or not. If
the red dot is flashing, heating is not completed
yet, and duration of fogging is only 1-3 seconds. If
the red dot is lighted and does not flash, heating is
completed, and duration of each fogging can reach
8-9 seconds.
DMX Control Operation
Use LED Display to set the unit to the desired
DMX512 address. Refer to DMX channel in chart.
1. Connect the DMX 512 controller cable to the in-
put socket (M of figure) of the fog machine unit.
Make sure the signal cable polarity is correct.
2. Plug mains power cord from the fog machine