NEO STEAM 1500 RGBA Manual De Usuario página 11

into appropriate power supply socket.
3. LED display (G of figure) shows "8888", and 26
LEDs (A of figure) around the nozzle all light
up. Please check if the LED letters shown on the
display lack of strips, and then show the current
software version.
4. 2 seconds after it switches to working status:
Heating up, it shows "HEAt". Setting function
value is allowed when heating up. With no op-
eration after 4 seconds, it goes back to "HEAt"
status.
5. Wait about 9 minutes for heating element to
heat up.
6. There are 6 DMX modes for choice; 1CH, 2CH,
3CH, 5CH, 7CH, & 9CH please choose the mode
by menu: It shows"d1" to "d9".
7. When completed heating, it shows control
mode: It shows ".dx" or "A.xxx", please set the
unit to the desired DMX 512 address, and DMX
control available, wireless control not available.
Your Steam 1500 RGB is now ready for opera-
tion with your DMX controller.
8. If desired, connect another fog machine: Plug
one end of another signal cable in to the output
socket (N of figure) on the back of the first
Steam 1500 RGB; plug the other end of the
signal cable to the input socket on the back of
the second Steam 1500 RGB. Follow the same
procedure to link more fog machine, if desired;
whole link is daisy chain.
• Manual fogging could be work with DMX
control operation at the same time.
• When shot down, the present function status
will be saved automatically and continue
when Powered on next time.
• If the red dot before the letters or in the
middle of the letters (.dx or A.xxx) on the
display is flashing, heating is not completed
yet, and duration of fogging is only 1-3 sec-
onds. If the red dot is lighted and does not
flash, heating is completed, and duration of
each fogging can reach 8-9 seconds.
P. 11
- Neo Steam 1500 RGBA
English version