Garland ROLL&COMB KEEPER 602-V23 Manual De Instrucciones página 24

English
Don't overdo it. Keep your feet firmly on the ground
and maintain balance at all times.
Be vigilant when walking on slopes or wet artificial
grass. Be especially careful when changing direction
on a slope.
Dress appropriately. Do not use this machine barefoot
or with sandals. Always wear sturdy shoes and long
pants.
Hold the machine with both hands on the handlebar
and always position your body behind the machine.
Keep all parts of the body away from moving parts
when the machine is running. Before starting the
machine, make sure that the brush is not in contact
with any object. A moment of carelessness while
operating the machine can cause your clothing or
other body parts to be damaged by the tool brush.
If the machine vibrates abnormally, stop the engine
and inspect the machine for the possible cause and
repair it. If you cannot find the reason, take your
machine to your technical service.
Do not leave this machine running unattended. If you
have to leave the machine unattended turn it off, wait
for the roller to stop and remove the battery.
Store battery powered tools with the battery
disconnected and out of the reach of children.
2.2.1. CLOTHING AND SECURITY APPAREL
Dress adequately. Do not wear loose clothing or
jewellery. Maintain your hair, your clothing and gloves
well clear of any moving parts. Loose clothing,
jewellery or long hair can get tangled on the movng
parts.
Use this machine with adequate shoes. Never use this
machine barefoot or with sandals. Use this machine
with long trousers.
When using this machine make use of the following
equipment: non slippery boots. We recommend you
use long trousers to reduce risk of personal injury
should any projectile be hurled by any moving part of
the machine.
The correct use of security equipment will reduce the
risk of personal injury.
You must carry with you:
• Tooling.
• Mobile phone (in case of an emergency).
2.3. SAFETY IN THE WORK AREA
Do not operate this machine in explosive atmospheres
as well as in the presence of flammable liquids, gases
and dust. Electrical machines create sparks that can
ignite dust or fumes.
Electrical machines create sparks that can ignite dust
or fumes.
The area within a radius of 15 meters
around the machine must be considered
a risk zone into which no one should enter while the
machine is running (Safety zone). When necessary,
use ropes and warning signs to mark the safety zone.
Keep children and bystanders away while
operating this machine. Distractions can
cause you to lose control. Make sure that
children, people or animals do not enter your work
area.
24/104