Porter Cable PCB420SA Manual De Instrucciones página 14

Fig. M
SANDING INSIDE CURVES (FIG. N)
CAUTION
!
To avoid injury, do not apply the end of the
workpiece to the idler drum (1). This could cause the
workpiece to fly up or cause kickback.
With care, freehand sanding of inside curves can be
accomplished on the idler drum (1). Never attempt to
sand the ends of a workpiece on the idler drum (1).
Fig. N
BELT VERTICAL SANDING (FIG. O, P)
Your belt / disc sander - belt station can sand vertically
as well as horizontally. Depending on operator needs
and the workpiece, the worktable can be used with
either the horizontal or vertical position.
To change from one position to the other:
1. Locate the 5 mm hex key.
2. Loosen the inner hex screw (1) by turning it counter-
clockwise.
3. Manually move the work support station into the
vertical or horizontal position, as required.
4. Retighten the inner hex screw (1) by turning it
clockwise.
1
2
3
1
Fig. O
Fig. P
14
1
1