Porter Cable PCB420SA Manual De Instrucciones página 7

TOOLS NEEDED FOR ASSEMBLY
Supplied
5 mm hex key
Not Supplied
Slotted screwdriver
Phillips screwdriver
Adjustable wrench
Combination square
Level
CARTON CONTENTS
UNPACKING AND CHECKING CONTENTS
Carefully unpack the belt / disc sander and all its parts,
and compare against the list below and the illustration
on the next page. Place the belt / disc sander on a
secure surface and examine it carefully.
WARNING
!
• To avoid injury from unexpected starting or electrical
shock, do not plug the power cord into a source of
power during unpacking and assembly. This cord
must remain unplugged whenever you are adjusting/
assembling the sander.
• The sander is heavy and should be lifted with
care. To avoid injury, get assistance to help lift the
sander.
• If any part is missing or damaged, do not attempt
to assemble the sander, or plug in the power cord
until the missing or damaged part is correctly
replaced.
TABLE OF LOOSE PARTS
ITEM DESCRIPTION
Belt / disc sander
A.
Miter gauge
B.
Disc worktable
C.
Belt worktable
D.
Hardware bag
E.
Handles & washers
Knob & washer
Hex key
Dust exhaust port
F.
Bag clamp
G.
Dust bag
H.
7
QUANTITY
1
1
1
1
2 each
1 each
1
1
1
1