Porter Cable PCB420SA Manual De Instrucciones página 2

SECTION
PRODUCT SPECIFICATIONS .........................................................................................................................
CALIFORNIA PROPOSITION 65 .....................................................................................................................
SAFETY GUIDELINES - DEFINITIONS ...........................................................................................................
POWER TOOL SAFETY ...................................................................................................................................
BELT / DISC SANDER SAFETY .......................................................................................................................
ELECTRICAL REQUIREMENTS AND SAFETY ..............................................................................................
TOOLS NEEDED FOR ASSEMBLY .................................................................................................................
CARTON CONTENTS ......................................................................................................................................
KNOW YOUR BELT / DISC SANDER...............................................................................................................
ASSEMBLY AND ADJUSTMENTS....................................................................................................................
OPERATION .....................................................................................................................................................
MAINTENANCE ...............................................................................................................................................
TROUBLESHOOTING GUIDE..........................................................................................................................
ACCESSORIES AND ATTACHMENTS ............................................................................................................
PARTS LIST ......................................................................................................................................................
WARRANTY .....................................................................................................................................................
MOTOR
Amps .......................
Voltage ....................
Hz ...........................
Horsepower ............
Speed .....................
Type.........................
BELT WORKTABLE
MITER GAUGE
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection. Use a seperate electrical
circuit for your tools. This sander is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120
Volt / 5 Ampere time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn,
cut or damaged in any way.
WARNING
!
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals know to the state of California to cause cancer, birth defects or other reproductive harm. Some examples
of these chemicals are:
● Lead from lead-based paints,
● Crystalline silica from bricks and cement and other masonry products, and
● Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out microscopic particles.
Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction
activities. Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into
your mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
Use of this tool can generate and/or disperse dust, which may cause serious and
WARNING
!
permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away from face and body.
2009/11
TABLE OF CONTENTS
PRODUCT SPECIFICATIONS
5 AMP
120 V
60
3/4 HP (Max. Developed)
3450 RPM (No load)
Induction
6-11/16 in. x 4-15/16 in.
(170 mm x 125 mm)
0 ~ 60° Right / Left
CALIFORNIA PROPOSITION 65
BELT
Speed ......................
Size .........................
DISC
Speed .....................
Size .........................
DISC WORKTABLE
DUST EXHAUST PORT
2
2160 FPM (No load)
4 in. wide x 36 in. long
(102 mm x 914 mm)
3450 RPM (No load)
8 in. diameter (203 mm)
10-25/64 in. x 5-29/32 in.
(264 mm x 150 mm)
2-1/2 in. O.D. (63.5 mm)
Printed in China
PAGE
2
2
3
4
5
6
7
7
9
10
13
16
17
18
19
24