Checking The Rotation Direction Of The Motor; Operation Of Operating Accessories - RIB K500 FAST Instrucciones Para El Uso Y La Manutención

E
N
G
L
I
S
H
C – CHECKING THE ROTATION DIRECTION OF THE MOTOR
Put DIP 1 in the ON mode
the gate starts closing
and the gate opens until it reaches the limit switch for opening position;
5 - After 2 sec. and within 10 sec. of continuous work, both in closing or opening,
the electronic clutch intervenes automatically. Adjust the force of the clutch by
turning the appropriate trimmer "TORQUE".
6 - After 10 sec. of continuous work, both in opening and closing, the automatic
deceleration is activated (if DIP 8 is on OFF position) Adjust the speed of the
operator requested during the deceleration by turning the appropriate trimmer
"LOW SPEED".
At the end of the control, and of the trimmers' adjustements, position DIP1 on
mode OFF.
ATTENTION: if the photocells and the safety strip are not connected, make sure
you bridge the contacts COM-PHOT and COM-EDGE before
proceeding with the programming. Otherwise the control board will
not enter the programming mode.
AT THE END OF THE PROGRAMMING PUT THE DIP 2 BACK ON OFF.
DURING THE PROGRAMMING THE SAFETIES ARE ACTIVE AND THEIR
INTERVENTION STOPS THE PROGRAMMING (THE LED DL2 WHICH WAS
LIGHTENING NOW HAS A COSTANT LIGHT). TO REPEAT THE PROGRAMMING
SET THE DIP 2 ON OFF), CLOSE THE DOOR FOLLOWING THE PROCEDURE
"MOTOR ROTATION SENSE CHECK" AND REPEAT THE PROGRAMMING
DESCRIBED ABOVE.
NOTE:
GRADUAL START
ELECTRONIC BRAKE
LED SIGNALS
The LED DL1 starts blinking
THE RED LED DL5 "CLOSE" comes on and
THE GREEN LED DL6 "OPEN" comes on
D - TIMING
E – RADIO CODE LEARNING PROCEDURE
(CRX MODELS ONLY)
PLEASE NOTE:
RADIO CODES CANCELLATION PROCEDURE
PLEASE NOTE:
MEMORY SATURATION SIGNALING
PLEASE NOTE:
OPERATION OF THE OPERATING ACCESSORIES
OPERATION BUTTON (COM-K BUTTON)
TIMER FUNCTION (automatic operation mode only DIP 6 OFF)
APPLICATIONS
RADIO TRANSMITTER
AUTOMATIC CLOSING FOR COMPLETE OPENING
RESTORING OF OPERATION FOLLOWING A BLACK OUT FAILURE
ATTENTION: If JP3 is closed the function black out is not active.
If JP3 is opened the function black out is active.
TAB1
A channel