Earlex SPRAY STATION GEMINI Manual De Instrucciones página 7

FF0084-A4-0312_Layout 1 09/03/2012 14:21 Page 7
Switch functionality
Pump Turbine
IMPORTANT:
Correct cleaning of this sprayer is essential for successful operation on next use.
Please refer to the How to DVD and the cleaning section of your operational manual on how to
properly clean your sprayer.
The Gemini can be set up for
spraying directly from the can for large projects and also from the
quart cup for small projects.
Fig.8
Fig.9
Fig.10
Paint speed dial Paint flow adjuster
two different types
Large Projects
Direct from the paint can (or Gemini bucket)
(water-based coatings only)
Product - Set up & Assembly
Additional items required before you start: • Drill • Cloth
Spraying direct from the can:
1) The head unit is secured with two container catches. Gently pull outwards on these to dislodge
the catches, and remove the head unit.
2) Unscrew the paint container (Fig.8) and remove the rigid suction tube from the gun (Fig.8) and
then insert the bare end of the 13ft paint tube through the connecting plate and fit it over the
inlet (this is the one with the smaller aperture on underside of the gun) (Fig.9).
Tip: Tube can be softened by running under hot water.
3) Ensuring that it is correctly aligned, screw the adapter onto the gun - pushing as you twist.
4) Fit the the 13ft paint tube to the paint outlet (Fig.10) on the motor unit - using the quick connect
fitting. Give a gentle tug on the paint tube to ensure that it is secure.
5) Set the paint flow adjuster on gun to maximum by scrolling up (Fig.10) and then firmly push/ clip
the gun into the docking station on the motor unit until you hear a 'click' (the trigger should be
depressed sitting in the docking station).
6) DO NOT FIT the air hose to motor outlet and gun at this stage yet.
7
HORIZONTAL ROUND
of applications,
VERTICAL
DVD