Set the required temperature.
3.
→ Page 43
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
three seconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Press the required temperature.
▶
To reach the set temperature, slide
the temperature controller for the
storage container to a position that
is one third from the bottom.
→ Page 43
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the storage container
temperature
To reduce the temperature, slide
1.
the temperature controller in the
direction.
for
To increase the temperature, slide
2.
the temperature controller in the
direction.
→ Fig.
5
Setting the freezer compartment
temperature
Press the required temperature.
▶
The recommended temperature in
the freezer compartment is
−18 °C.
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.
Note: When Super cooling is
switched on, increased noise may
occur.
Switching on Super cooling
Press
(Refrigerator compart-
▶
ment).
(Refrigerator compartment)
a
lights up.
Note: After approx. 6 hours, the ap-
pliance switches to normal operation.
Switching off Super cooling
Press
(Refrigerator compart-
▶
ment).
8.2 Super freezing
With Super freezing, the freezer com-
partment cools as cold as possible.
Switch on Super freezing four to
six hours before placing food weigh-
ing 2 kg or more into the freezer
compartment.
Additional functions en
43