Alecto BW600 Manual De Instrucciones página 28

Defrost/milk warming:
1. Always place the basket into the bottle warmer first before adding a bottle/jar. Do never place
the bottle/jar directly onto the heating element.
2. Fill the bottle warmer with water until the level of the milk in the bottle or the nutrition in the
jar. Regardless of the amount of milk/food, the water should not exceed the MAX level,
indicated in the inner rim. It is recommended to use distilled water, in connection with
possible scale formation.
3. Turn the knob to select the
frozen milk or food is ready after about half an hour/hour, depending on the type of food,
quantity and material in which it is heated. The final temperature may also vary slightly due to
different milk or formula volumes and the material of the bottle or jar.
Note: It is normal that the indicator will alternately turn "on and off". The bottle warmer itself
will automatically adjust the temperature to ensure the heating milk/food evenly.
Note: To defrost completely, shake the bottle or stir the food from time to time.
Note: The milk/food after defrosting should not be fed immediately.
4. Note there is no timer on the BW600. So count the time yourself and remove the bottle/jar
from the bottle warmer after the indicated time has run out.
5. Gently shake the bottle or basket and check the temperature before you are feeding the
baby. Check the temperature by sprinkling a few drops on the inside of your wrist. Or taste of
feel the food when it's not too hot.
Tip: When you find the milk/food is not warm enough, place the bottle/jar back into the basket
for maximum 0,5 min/1 min for extra warming. (Fill a small amount of water into the bottle
warmer when the water has dried out and then restart). This will cause a slightly warmer
result but without overheating.
Caution: If you leave the bottle/jar into the bottle warmer longer than one hour, the
milk/food may become overheated. Cool before feeding.
Note: If you use overheated breast milk or nutrition, valuable nutrients and vitamins may be
lost.
6. When the defrosting is completed, turn the knob to OFF.
Caution: The water in the bottle warmer may be hot after finishing the defrosting. Be
carefull the water can causes serious burns. If you do not turn the knob into to OFF
function, the water keeps heating up and will reach a very high temperature.
7. If the water has dried out, the reset switch will be triggered to shut off the power. Wait
10 minutes to cool down and then press the reset switch (until you hear a clicking sound)
restart the warming.
8. Before defrosting a second bottle or jar, it is best to wait 10 minutes for the bottle warmer to
cool to prevent overheating or pour cold water into the bottle warmer.
function. The power light is alternately on and off. The
28