Alecto BW600 Manual De Instrucciones página 29

Food warming:
1. Always place the basket into the bottle warmer first before adding a jar. Do never place the
jar directly onto the heating element.
2. Fill the bottle warmer with water until the level of the nutrition in the jar. Regardless of the
amount of food, the water should not exceed the MAX level, indicated in the inner rim. It is
recommended to use distilled water, in connection with possible scale formation.
3. Turn the knob to select the
food is ready after about half an hour. It may take longer or shorter, depending on the type of
food, volume and material in which it is heated. The final temperature may also vary slightly
due to different types of food, volumes and the material of the jar.
Note: It is normal that the indicator will alternately turn "on and off". The bottle warmer itself
will automatically adjust the temperature to ensure the heating food evenly.
Note: To warm completedly, make sure to stir the food from time to time.
Note: The food after warming should not be fed immediately.
4. Note there is no timer on the BW600. So count the time yourself and remove the bottle from
the bottle warmer after the indicated time has run out.
5. Gently stir the food and check the temperature before you are feeding the baby. Check the
temperature by feeling or tasting the food.
Tip: When you find the food is not warm enough, place the food back into the basket for
maximum 0,5 min/1 min for extra warming. (Fill a small amount of water into the bottle
warmer when the water has dried out and then restart). This will cause a slightly warmer
result but without overheating.
Caution: If you leave the jar into the bottle warmer longer than one hour, the food may
become overheated. Cool the food before feeding.
Note: If you use overheated food, valuable nutrients and vitamins may be lost.
6. When the warming is completed, turn the knob to OFF.
Caution: The water in the bottle warmer may be hot after finishing the warming. Be
carefull the water can causes serious burns. If you do not turn the knob into to OFF
function, the water keeps heating up and will reach a very high temperature.
7. If the water has dried out, the reset switch will be triggered to shut off the power. Wait
10 minutes to cool down and then press the reset switch (until you hear a clicking sound)
restart the warming.
8. Before warming a second jar, it is best to wait 10 minutes for the bottle warmer to cool to
prevent overheating or pour cold water into the bottle warmer.
function.The power light will alternately turn on and off. The
29