Braun CareStyle 7 Manual De Instrucciones página 17

Steam comes out
under the base unit.
There are some water
drops from the holes
in the bottom of the
soleplate.
Brown coloured
fluid leaks from the
soleplate.
The first time the
appliance is turned
on, you notice smoke
or smell.
The appliance emits
an intermittent noise
associated with
vibrations.
The closure is difficult
to unscrew.
After refilling the water
tank, the icon does
not reset.
All LEDs are flashing.
The "max" pressure safety
system has opened.
Water has condensed
inside the tubes because
steam is being used for the
first time, or has not been
used for some time.
Chemical water softeners or
additives have been poured
into the water tank.
Some parts have been
treated with sealer/
lubricant which evaporates
the first time the iron heats
up.
Water is being pumped into
the boiler.
Lime scale has made the
closure difficult to open.
The boiler is still under
pressure.
The water float does not
work appropriately.
The water tank is not posi-
tioned correctly.
System error.
Turn the appliance off immediately
and contact an authorised Braun
Customer Service.
Press the steam button several
times away from the ironing
board. This will eliminate cold
water from the steam circuit.
Never pour products into the water
tank. Clean the soleplate with a
damp cloth and rinse the boiler.
This is normal and will stop
when you have used the iron a
few times. If the smoke/smell is
still present after turning off the
appliance, contact an authorised
Braun Customer Service.
This is normal and no action is
needed.
Turn the cap forcefully. To avoid
the problem, descale the system
frequently.
Never open the closure if the
boiler is still under pressure or
hot. Wait at least 2.5 hours before
opening the closure.
Empty the water tank, rinse out
and refill.
Position the water tank correctly.
Unplug the appliance, plug it in
again and press On/Off button. If
this problem is still present, turn
the appliance off immediately,
unplug and contact an authorised
Braun Customer Service.
17