GYS GYSPRESS 10T PUSH-PULL Manual Del Usuario página 17

CONNECTOR ASSEMBLY
Screw the required connectors kit for the riveting procedure in the arm support. Before assembling, check that the die
and the punch support are correctly in place (see page 3) and screwed.
Punch / mandrel support
As soon as the matrix and the punch support are in place, tighten with the spanner
provided. Check that the connection tips are in place after each riveting process. A release is
dangerous and may damage the riveting machine.
SPEED AND PRESSURE CONTROL
The user can adjust manually the speed of the actuator as well as
rivet installation pressure according to the type of material in order
to avoid distortion.
See page 77 in order to adjust the pressure according to the
material and matrix.
RIVET BOX INCLUDED
The riveting machine is delivered with a box of 300 self-piercing rivets.
These sample rivets are provided to allow a test of the machine. They are
specific to car body repair.
GYSPRESS 10T PUSH-PULL
Rivet matrix
Speed Pressure
EN
17