Network Assistant; Setting Time/Date - auna SELECT Unison Retrospective Manual De Instrucciones

EN
52

NETWORK ASSISTANT

When using the device for the first time, the network wizard is started
and runs through the settings for date/time and network. Once this is
completed, the device can be used in most modes.
Important notes on the network wizard
• If you want to change these settings later, go to Menu > System settings
>. If you want to go through the network wizard again, select Menu
> System settings > Setup wizard. Select "Yes" to start the network
wizard.
• If you select "No", the next screen will ask if you want to run the
Network Wizard automatically the next time you start the device. The
device is then started without time/date and network settings and
displays the main menu.
• If the power connection is disconnected while the network wizard is
activated, it is called up again as soon as the device is started.
12/24 hour format
Select "Set 12/24 hour" to set either 12- or 24-hour format.

Setting time/date

The date and time are displayed as DD-MM-YYYY and hh:mm AM/PM. The
first value "DD" is active (flashing). Adjust each value with the rotary control
and confirm your selection by pressing the rotary control. As soon as a
value has been confirmed, the next value is activated and can be set.