Safety Instructions - Groway Bulldog Serie Manual De Usuario

G65M / G130 / G1300 / D1000 /*D900
PREVENTION AND SAFETY
If the tiller is operated follow those indicated in the manual, it will work safely and
reliably. Before operating the mini tiller, please read this manual carefully. Otherwise,
injures and device damage will be caused.

SAFETY INSTRUCTIONS

ATTENTION
• When starting engine, please turn gear lever to neutral position.
• When the machine is working, please pay attention to safety!
• Be careful about the rotary blades, because they may hurt you!
• Fuel and lube oil must be clear.
• Before shifting the gear , you must disconnect the clutch. When holding the backshift bar, the
gear lever must be put in the neutral position.
• Gasoline is flammable, you must pay attention to fire and exploding.
As model is always improved, photos or illustrations may have difference comparing the actual
machine.
WARNING
Exhaust gas contains poisonous carbon monoxide. Never run the tiller in enclosed areas. Be sure
to provide adequate ventilation. When installing, ventilated protection is to be observed
The rotating parts are sharp and running at high speed. Accidental contact can cause
serious injury.
Keep your hands and feet away from the parts while engine is running .
Stop the engine and disengage the tines clutch before inspection or maintenance of
the tines.
Disconnect the spark plug cap to prevent any possibility of accidental starting .Wear
heavy gloves to protect your hands from the tines when clearing the tines or when
inspecting or replacing the tines
• GROWAY advises to use the machine exclusively for the purpose it has been designed, and to
follow thoroughly the indications and the explanations given in the manual/
• Do not incline or turn the machine upside down when there is fuel in the tank; fuel is highly
flammable and burn.
• Do not apply implements different from those produced by GROWAY and indicated on the
enclosed manual,if these are not authorized by GROWAY engineers or by authorized dealers.
• Do not use the machine having the handle in tractor position and the cutter bar, the bush-
cutter, the snow-thrower or other front implements mounted.
• Do not use machine having the handle in tractor position and the sickle-bar-cutter,the lawn
mower,the bush-cutter,the snow-thrower or other front implements Mounted.
• Do not use fast connection or other possible extensions with the rotary hoe since they could
approach the rotary hoe to the operator's feet and therefore not comply the security regulation
pr EN 709, 1992.
• Just one operator must use the machine,keep away possible observers
24