To Start The Machine - Groway Bulldog Serie Manual De Usuario

G65M / G130 / G1300 / D1000 /*D900

6. TO START THE MACHINE

Ensure that gear lever and PTO lever are disengaged.
1) Pull the engine Stop-lever A, Set the Clutch control lever B and Clutch control lever C in initial
position (fig.14). Set the throttle at half-way position.
2) Set engine for starting as described in the engine manual.
3) Slowly pull the starting handle until the hooking system is engaged, then give a strong pull
placing the foot (fig.16).
The rope handle must always be grasped with ONE HAND ONLY, to prevent the engine "kicking
back".
When the engine has started, allow it to run idle for some minutes to allow oil to lubricate all moving
parts.
First pulled the down clutch handle C, and then press down the above clutch handle B (locking
structure, prohibit press down the above clutch handle B directly).
Engage and locate the speed control to the desired speed position. If the gear does not engage
immediately, release the clutch lever C slightly and "feel-in". when the gear is engaged release the
clutch lever C slowly and fully until the machine starts.
To engage drive to the implement, engage the clutch lever and locate the control rod in its forward
position. If engagement is not immediate, release the clutch lever C slightly and "feel-in".
Please note that on two-wheel tractors it is impossible to engage reverse speed and the rotary
hoe simultaneously moving to a safety device. The P.T.O.must be disengaged before locating reverse
gear. Accelerate engine and release clutch lever slowly and fully, to begin work. To stop engine and
machine: decelerate, disengage the P.T.O. and speed control rods to neutral position and fully release
the stop-lever A (fig.13).
Lubrication and maintenance
A proper maintenance and lubrication will help keep the machine in a perfect working condition.
The machine is delivered full of lubricants,however check oil levels before starting work. Check that
all screws and nuts are well tightened; particularly nuts D (fig.10) that fix the attachments to the
machine, the nuts that fix wheels and ones fixing the engine. Lubricate the sliding bushes of the
steering column stop rod.
Clutch
Originally, the position of A lever (fig.17) is normal.
Engine
For the maintenance intervals follow the instructions given in the operating manual of engine. You
should check the oil level every 4 hours of work and replace it every 50 hours of work. Always use
Fig. 14
30
Fig. 15