Display Functions; General Operations - OHAUS Frontier 2000 Serie Guia Del Usuario

TM
Frontier 2000 Centrifuges

Display functions

Sections of the display are explained as following.
Prog
Program switching
Time
Run time (maximum: 99 minutes and 59
seconds, minimum: 1 second)
3.2 Buttons
Functions of buttons on the control panel are listed as below. If a setting is activated by pressing the
corresponding button or combination, the display of the parameter will start flashing.
Prog
Program switching (A-L 9 groups of
programs can be called)
Prog
Set increment button
Stop and Open
Stop
Stopping operation and opening the
Open
lid

3.3 General operations

Notes:
To re-start the centrifuge after a run, one must open and close the lid once (If this is not the case, the
word "E1" inside the time-display will flash), which is a build-in safety feature.
All liquid handling must be performed outside of the centrifuge to avoid spilling.
Before using the emergency lock release, please make sure the rotor has stopped completely by
check through the see- through port on the lid.
Use emergency lock release to open the lid as described in the manual if the safety lock was
triggered.
All places of swing out rotors must be occupied with at least buckets and racks.
ATTENTION:
Check that the fixing screw is properly installed before each run.
Do not operate the centrifuge with rotors or buckets which show any signs of corrosion or
mechanical damage. Do not operate with extremely corrosive substances, which could
damage the rotor, buckets and materials.
In case of any questions, please contact the manufacturer!
RPM/RCF
Revolutions per minute and
reactive centrifugal force display
switching
Acc/Dec
Acceleration rate and
deceleration rate (gears 0-9)
Set
Parameter
(Revolutions
Set
centrifugal
centrifugal time and Acc/Dec rates can
be set accordingly)
Set decrement button
Start
= Start the centrifugation (only start if the
Start
lid is securely closed)
setting switching
per minute, reactive
force, rotor number,
EN-5