Electrical Connection - Fagor VISUAL PLUS VPE-061 Manual De Instrucciones

VISUAL PLUS INSTRUCTIONS MANUAL
ENGLISH

ELECTRICAL CONNECTION

An AUTHORISED TECHNICIAN should always carry out the appliance's electrical
connection.
The legal standards in force in each country on connections to the mains should be
taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use polychloroprene cable sleeves or other similar materials (Ho5RN-F).
A switch device should be installed next to the appliance for all the phases, with a gap
of a minimum of 3 mm between contacts. This switch will be equipped with fuses.
The appliance must be earthed, from the connection strip of the appliance to the earth
connection of the main power supply.
The manufacturer will not be held liable for damage originated by failure to observe this
requirement.
To access the connection strip, release the left side panel (Fig. 8), pass the cable hose
through the stuffing box on the exterior base and connect as shown on the strip.
Fig. 8
VERY IMPORTANT: Before installing the left side panel, attach the electrical supply
hose securely to the stuffing box.
When several appliances are installed in series, they should be earthed to each other
using the point assigned for this purpose, located in the fryers base, at the back.
44