GB
CLEANING
It is important to keep the appliance clean and in good working order to ensure optimum quality of
the products and long life of the appliance.
Cleaning of the appliance must be carried out by persons with knowledge and practical
experience of the appliance.
At the end of each working day, clean the outer surfaces dirty with coffee (motor housing, tray,
discharge opening etc.). Clean the appliance completely at least once a week.
Always disconnect the plug of the appliance from the power socket before cleaning it.
Clean the motor housing and the tray with a cloth dampened with water or alcohol.
Wipe with a dry cloth.
Never put the appliance under running water and never immerse in water.
Once the hopper has been removed, it can be washed with lukewarm water and neutral soap,
then rinse it and dry well. To reassemble it, hook the tooth in the rear part of the hopper in its
seat (1, Fig. 27).
Use a brush or a paintbrush (Fig. 26) to clean the most hidden areas inside the unit and a dry
cloth for the other surfaces.
Warning:
When removing the panel from its housing, pull slowly so as not to damage its
connector.
To clean the head remove the four screws (2, Fig. 27) that secure it.
63
Fig. 26