Easy Ice; Maintenance And Care; Cleaning - KitchenAid WRM22CKTWW Manual Del Usuario

IMPORTANT:
Before repositioning the storage tank on the
door, make sure that:
• The valve has been positioned correctly;
Check that the valve top is making contact
with the top located on the storage tank.
• The insulation ring is correctly placed in the
tank as shown in the following fi gure.
To place the storage tank back in the refrigerator door:
1. Assemble the valve to the tank by turning it clockwise, insert the cap strap
into the tank cap and snap the cap into place.
2. Finally, place the tank on the door by holding it with both hands and tilting
it slightly upwards, hook it onto the side legs of the internal wall of the door
and push it down until it is fi rmly held.
Note:
Make sure that the storage tank has been positio-
ned correctly over the door and that there is no pos-
sibility of it falling over.
Droplet collecting grid
The droplet collection grid is used to store any drips or spills during the use of
the water dispenser.
To clean the collection grid, it is necessary to remove it from the refrigerator. This
is done by pulling it directly outward.
To insert it, place it in position and slide it forward.

EASY ICE

Use of the ice maker (Easy ice):
• To make ice cubes, remove the ice cube holder by
pulling it toward you.
• Fill the trays and place the bracket back into the
housing.
• The ice making time depends on the room tem-
perature, food loading conditions in the refrigerator and freezer door ope-
nings. If you need ice, quickly set the temperature control on your refrigerator
to position 4 or 5.
To remove the ice cubes
• Turn the knobs as shown until the ice cubes fall into the tray.

Maintenance and Care

CLEANING

Risk of explosion
Don´t use flammable cleaning products.
Failure to do so may result in death, explosion, or fire.
40