Fromm & Starck STAR ATFE 12 Manual De Instrucciones página 27

Step 4:
VII. Connect all cables to the sockets in the control box (11):
• connect the signal cable from the control panel to the socket (G1),
connect the power cord to the socket (G2),
•
• connect the signal cable from the lifting column to the socket (G3).
Step 5:
VIII. Install the desk top, the control box (11) and the control panel (11).
IX. If an extension of the crossbeam is required, proceed as follows:
• loosen (L),
move (P),
•
• tighten (T).
X. Attach the desktop with screws (E), install the control box (10) with screws (E),
then install the control panel (11) with screws (14).