Tabla de contenido
Publicidad
LOCATION OF CONTROLS
1)
LCD DISPLAY
2)
ENTER/CD PLAY/PAUSE
3)
CD STOP
BUTTON
4)
MEMORY/PROGRAM BUTTON
5)
FUNCTIONS SELECTOR
6)
BAND/FOLDER SELECTOR BUTTON
7)
REPEAT / M-UP BUTTON
8)
CD SKIP / RADIO TUNING DOWN
9)
CD SKIP / RADIO TUNING UP
10) USB SOCKET
11) STEREO HEADPHONE JACK
12) CD DOOR OPEN BUTTON
13) STANDBY LED INDICATOR
14) REMOTE SENSOR
15) POWER ON/STANDBY BUTTON
16) VOLUME UP/DOWN BUTTON
17) MENU BUTTON
18) MEMORY CARD SLOT
19) USB/CARD SLOT COVER
20) FM WIRE ANTENNA
21) SPEAKER WIRE CONNECTOR (L/R)
22) AUXILIARY INPUT JACK
23) AC POWER CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.
IMPORTANT:
SINCE MOVEMENT OF THE CD MECHANISM AND THE SENSITIVE CIRCUITY MAY CAUSE INTERFERENCE TO
THE RADIO TUNER NEARBY, SWITCH THIS UNIT OFF WHILE OPERATING OTHER RADIO DEVICES.
PRECAUTIONS FOR USE
INSTALLATION
UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAIN VOLTAGE AND BEFORE ALL
OTHER CONNECTIONS HAVE BEEN MADE.
DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
CONNECTION
1. CONNECT THE POWER CORD TO AC OUTLET
2. WHEN YOU FIRST PLUG THE UNIT INTO THE MAINS, THE UNIT WILL GO INTO STANDBY MODE AND THE
LED INDICATOR (13) WILL LIGHT UP, THE DISPLAY WILL SHOW " -- -- : -- -- " AND FLASHING.
3. CONNECT THE SPEAKER WIRE TO THE SPEAKER TERMINAL (21) LOCATED ON THE REAR SIDE OF UNIT.
4. TURN ON THE POWER (15), IF THE LCD DISPLAY IS ON WITH BACKLIGHTING, IT MEANS THE POWER
SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY TO PLAY THE MUSIC.
SETTING THE CLOCK
1.
PRESS THE " MENU " BUTTON (17) TO SELECT " CLCOK " MODE.
2.
PRESS THE " ENTER " BUTTON (2) AND THE FIRST & SECOND DIGIT OF "00" IS START FLASHING. PRESS
OR
BUTTON (8,9) TO SET THE CORRECT HOUR. PRESS " ENTER " BUTTON (2)TO STORE THE CORRECT
HOUR.
3.
THE THIRD & FOURTH DIGIT OF "00" IS FLASHING, PRESS THE
CORRECT MINUTES. THEN PRESS " ENTER " (2) TO STORE THE CORRECT MINUTE.
THE PRE-SET TIME WILL BE RE-SET COMPLETELY IF DIS-CONNECTING THE MAIN POWER SUPPLY.
YOU ARE RECOMMENDED TO SWITCH THE SYSTEM INTO STANDBY MODE FOR CONVENIENCE
USAGE.
BUTTON
BUTTON
BUTTON
GB-1
OR
BUTTON (8,9) TO SET THE
Publicidad
Tabla de contenido
