B4. Adapting Microwave Blower For Outside Back Exhaust - Avanti MOTR14K3S-IS Instrucciones Para Instalación

B4: ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST
1) Remove and save screw that holds blower motor to microwave, lift up the blower plate.
2) Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
3) Remove " Parts A " with Nipper or Scissors
4) Rotate blower unit counterclockwise 180º
5) Rotate blower unit clockwise 90º
6) Place the blower unit back into the opening.
CAUTION:
Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
NOTE:
The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
7) Replace the blower plate in the same position.
8) Attach the exhaust adapter to the rear of the oven
by sliding it into the guides at the top center of the
back of the oven.
Push in securely until it is in the lower blower motor
screw. Take care to assure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
9) Secure the blower motor unit to the microwave with
screw as before.
10) Secure the blower plate to the microwave with
screw. Repalce the plower plate in the same
position.
B lower Motor
Back of
Microwave
Blower Plate screw
Blower motor screw
20
BEFORE : Fan Blade
Openings Facing UP
Before
Back of
Microwave
Before
Back of
Microwave
Openings Facing Back
End B
Adaptor
Guide
Adaptor
Blower Motor screw
Adaptor
Blower plate screw
Part"A"
Back of
Microwave
Back of
Microwave
End A
Back of
Microwave
Guide
Blower Motor screw
Blower Plate
Back of
Microwave
Blower Plate
Back of
Microwave
Blower Plate
& Adaptor screw