Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PLACEMENT OF THE MOUNTING PLATE
A. REMOVING THE MICROWAVE OVEN FROM THE CARTON / REMOVING THE MOUNTING PLATE
1.
Open the carton and remove the upper foam from
the box, but remember to keep the accessories.
2. Pull the oven out of the carton and remove the
plastic bag carefully.
3. Take the mounting bracket out from the upper
foam.
B. FINDING THE WALL STUDS
1. Find the wall studs, using one of the following
methods.
a)
Wall stud finder – a magnetic device which
locates nails.
Or
b) Use a hammer to tap lightly across the
mounting surface to find a sold sound. This will
indicate a wall stud location.
2. After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the
wall stud. Then place a mark halfway between the
edges. The center of any adjacent wall studs
should be 16" to 24" from this mark.
3. Draw a line down the center of the wall studs.
THE MICROWAVE MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
Step – by – Step Installation Guide
the upper foam
8
oven
ca rton
Wall Studs
Wall Studs Center
pl a s �c ba g
Blower Plate
Blower Plate screw
Back of
Microwave
Publicidad
Tabla de contenido
