Changing The Dust Bag; Cleaning The Foam Filter - Maxvac DV15 MB Instrucciones De Uso Y Mantenimiento

USING THE DUST BAG
Use the dust bag only
when the filter cartridge is
installed. To pick up dust of
class 'M' the dust bag must
be installed in the appliance.
Introduce the fibre bag into the waste
drum.
Fit the plastic flange (X) into the air inlet
connector (Y). Be careful not to damage
the bag.
Fit the bag to the sides of the drum
and attach the motor unit. hen using
the bag, the dirt can be removed more
hygienically.

CHANGING THE DUST BAG

Change the bag when the luminous LED
(C) switches on.
Remove the plastic flange (1) from the air
inlet connector (2).Take out the full bag.
Close the plastic flange with the cap
provided.
1
2
18
DV 15 MB
X
Y
The bag should not be reused
and must always be changed.
Dispose of the bag in compliance
with the special waste disposal
regulations in force in your
country
MAX-VAC.COM
FOR USE AS A WET VACUUM
Always remove the filter
cartridge and the paper filter
bag, if fitted. Use the foam
filter. The foam filter is not
suitable for vacuuming Class
'M' dust.
When the vacuumed liquids reach the
maximum level inside the drum, suction is
automatically cut off by the safety float. The
user is alerted by an increase in the RPM
rate of the motor and the lack of suction.
Turn off the appliance immediately and
empty the drum.
VACUUMING LARGE
QUANTITIES OF LIQUID
To ensure partial airflow, make sure
that the crevice tool is never fully
submerged.
CLEANING THE FOAM
FILTER
Rinse the foam filter with
water. DO NOT use detergent.
Replace if worn or torn.
DV 15 MB MAX-VAC.COM 19