Checking For Proper Damper Operation; Mount The Microwave Oven; Important - Hisense HMVZ173SS Instrucciones De Instalación

A3.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
5 Secure blower unit to microwave with the screw
removed in Step 1. Make sure the screw is tight.
6 Replace blower plate with the screws removed in
Step 1. Make sure the screws are tight.
Attach the exhaust adaptor to the top of the
7
blower plate by sliding it into the guides of the
blower plate.
Adaptor
Guide
Locking Tab
Push in securely until it is in the locking tabs.
Take care to assure that the damper hinge is
installed so that the
CHECK FOR PROPER
A4.
DAMPER OPERATION
Blower Plate
Exhaust Adaptor
•
Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
•
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
Installation Instructions
Back of
Microwave
Back of
Microwave
damper swings freely.
Damper
Back of
Microwave
A5. MOUNT THE MICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle
or heat shield during installation. Do not
remove the cardboard spacers between the
heat shield and door.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
NOTE: When mounting the
microwave oven, thread
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
2 Rotate front of oven
up against cabinet
bottom.
3
Insert a self-aligning screw through
cabinet holes.
Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
EN-14
1 Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
one of the top