Publicidad
Idiomas disponibles
Idiomas disponibles
Locking button:
- To activate this function press button (C) while
holding down the start-up switch.
- To deactivate this function press the start-up
switch right down.
Once you have finished using the appliance:
- Stop the appliance by releasing the on/off switch.
- Clean the appliance.
Cleaning
- Disconnect the appliance from the mains and al-
low it to cool before undertaking any cleaning task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO NOT IM-
MERSE IN WATER OR ANY OTHER LIQUID.
- Clean the equipment with a damp cloth with a few
drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products, for
cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of the
appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- If the appliance is not in good condition of cleanli-
ness, its surface may degrade and inexorably
affect the duration of the appliance's useful life and
could become unsafe to use.
Supplies
- Always use original supplies, designed specifi-
cally for your appliance model.
- These supplies are available in specialist shops.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If the connection to the mains has been dam-
aged, it must be replaced, take the appliance to
an authorised technical support service. Do not
attempt to disassemble or repair the appliance by
yourself in order to avoid a hazard.
Specifications:
Model
Rated Power
Rated Voltage
Rated
Frequency
No load speed
Impacts per minute
Electronic speed
control
Maximum capacity
Drill Chuck capacity
Reversible
Weight
Sound pressure lvl
Sound power
lvl
Drilling
Vibration
Impact Drilling
Vibration
NB: These specifications are subject to change
without notice of purpose of improvement.
-Measured sound level determined according
EN60745
-The vibration emission level given in this informa-
tion sheet has been measured according EN60745
and may be used to compare one tool with other.
It may be used for a preliminary assessment of
exposure
-The vibration value during actual use of the
power tool can differ from the declared total value
depending on the way in which tool is used
-It's necessary identify safety measures to protect
the operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For EU product versions and/or in case that it is
ID1050REAK
1050W
230-240 V~
50 Hz
0-3000 rpm
0-48000 bpm
✓
Steel:
Wood:
Masonry:
Ø 13mm
✓
2,1 Kg
L
= 103 dB(A)
WA
K = 3 dB(A))
L
= 92 dB(A)
PA
K = 3 dB(A)
a
= 5,39 m/s
2
h,D
K
= 1,5 m/s
2
D
a
= 14,63 m/s
2
h, ID
K
= 1,5 m/s
2
ID
Publicidad
