Replacing The Lamp - Whirlpool OAKZ9 379 P IX Guía Rápida

REPLACING THE LAMP

1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
TROUBLESHOOTING
Problem
The oven is not working.
The display shows the letter "F" followed
by a number or letter.
The door will not open.
Policies, standard documentation and additional product information can be found by:
• Visiting our website
• Using QR Code
• Alternatively,
When contacting our After-sales Service, please state the codes provided on your product's
identification plate.
Possible cause
Power cut.
Disconnection from the mains.
Oven failure.
Cleaning cycle in progress.
docs . whirlpool . eu
contact our After-sales Service
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
Solution
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Contact you nearest Client After-sales Service Centre and
state the number following the letter "F".
Wait for the function to finish and for the oven to cool
down.
(See phone number in the warranty booklet).
XXXXXXXXXX XXXXXX XXXXXX XXXXX XXXXXXX
Model: xxxXXXXxx
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX XXXXXX
XXX X X X X X XXX XX XXXX X X X