KALLISTA TurnSpray P22076 Instrucciones De Instalación página 3

INSTALLATION INSTRUCTIONS
Multiple Bodyspray Installations
‰ Route the water supply lines.
‰ If installing more than one bodyspray off the same supply line, construct a pressure balancing loop. Locate a
tee along the loop at each bodyspray installation location.
‰ Do not strap the pipes at this time.
Single Bodyspray Installations
‰ Route the water supply line.
‰ Install an elbow to the end of the supply pipe at the bodyspray installation location.
All Installations
‰ Temporarily install a nipple to each tee/elbow. Do not use any sealant.
‰ Verify that the nipple(s) will extend 1/2" beyond the finished wall when fully tightened.
‰ Install appropriate backing and strap the pipes.
‰ Finish the wall.
‰ Verify that the hole in the finished wall is 1-1/8" in diameter.
‰ Install a 1/2" NPT pipe nipple so that it extends 1/2" beyond the finished wall when fully tightened.
‰ Run water through the system to flush out dirt and debris.
‰ Apply sealant tape around the exposed threads of the pipe nipple.
1506285-2-A
3 of 11
1. INSTALL THE SUPPLY PIPING
Multiple Bodyspray Installation
Water Supply
Pressure Balancing Loop
2. INSTALL THE PIPE NIPPLE
Finished Wall
TurnSpray
Single Bodyspray Installation
Nipple
1-1/8"
(2.9 cm)
1/2"
(1.3 cm)
1/2" Pipe Nipple
Apply sealant tape.
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Bodyspray
™
Nipple