Assembly Of The Appliance - Infiniton HBF-5205 Manual De Instrucciones

ASSEMBLY OF THE APPLIANCE

Before proceeding with the assembly, make sure you have removed all the protective material
used for packing and transporting the appliance.
Once the stove has been removed from its packaging, examine it to make sure it does not show
obvious damage. In case of any doubt, do not use the appliance and contact a specialist
technician. The packaging material should not be left within the reach of children, as it could be
dangerous. Discard it according to what is established by the regulations in force.
1. Slide down the base plate used as support
for the gas bottle.
2. Secure the base plate to the rear housing
of the appliance using 4 screws with their
corresponding washers.
STEP 1
· Differences in the device may be observed with respect to the illustrations or instructions in
the manual. This should not be interpreted as a quality problem, but rather as a consequence
of the improvements implemented in the product.
· The appliance must only be used with a LPG gas cylinder of less than 15 kg.
· The regulator used must be approved in accordance with standard EN16129 and the gas
hose must be approved according to standard EN16436-1 and have a length of less than 50 cm.
⚫ Connect one end of the hose to the pressure regulator and the other end to the gas stopcock.
Make sure that the connections are tight and that none of the connection components or fittings
are damaged.
· Before connecting the cylinder, make sure that your stopcock is closed and that there are no
open flames (oven on, etc.) in the vicinity. Also, check that the sealing gasket is in good
condition. Next, screw the pressure regulator in the cylinder.
· Connect the regulator to the stop valve and firmly tighten the nut by turning it
counterclockwise.
1. Attach the cylinder retaining cap to the slots
on the side edge of the device housing.
STEP 2
1. Fold the base plate, on which the gas cyliner
will stand, downwards.