Testing The Refrigerator; Replacing The Side Brackets - Dometic CCF-T/GM-T1 Serie Manual De Instalación Y Funcionamiento

GMT1XXCCFT Refrigerator
7 Removing the Electrical Connections
Center Console
q
12 V Rear Power
w
Connector Red Tab
3. Remove the red tab from the 12 V rear power connector.
4. Disconnect the 12 V rear power connector from the
console back panel.
5. Disconnect all remaining electrical connections from
the console back panel, and set the console back
panel aside.

6 .4 Testing the Refrigerator

I The console lid should remain open during the pre-
installation and installation procedures.
1. Place the refrigerator unit upright on the floor, near
the rear of the console (second row area).
2. Insert the vehicle's 12 V rear power connector into the
refrigerator unit's 12 VDC power cord plug.
3. Start the vehicle engine.
4. Confirm the blue LED is illuminated on the refrigerator
unit's ON/OFF button. If not, press and hold the
button for one second, and then release.
EN
q
w
e
r
12 V Rear Power
e
Connector
Console Back Panel
r
5. Listen for the condenser fan to start. See
"Troubleshooting" on page 14 if the condenser
fan does not start.
6. Turn the vehicle engine OFF.
7. Press and hold the ON/OFF button to turn the
refrigerator unit OFF.
8. Unplug the 12 VDC power cord.
9. Set the refrigerator unit away from the console.

6 .5 Replacing the Side Brackets

q
8 Replacing the Side Brackets
Side Bracket
q
Screws
w
1. Open the console bin to locate the side brackets.
2. Use a T20 Torx screwdriver to loosen and remove the
screws from each side bracket.
Retain the screws.
I
3. Remove the existing side brackets.
I Retain the side brackets.
4. Insert the provided mounting brackets.
5. Reverse these steps to install the new mounting
brackets.
Preinstallation
w
e
Console Bin
e
9