Preparing The Front Fan Opening; Preparing The Rear Power Connector; Location - Dometic CCF-T/GM-T1 Serie Manual De Instalación Y Funcionamiento

Preinstallation

6 .6 Preparing the Front Fan Opening

NOTICE: For vehicles with a Bose
exceed a drilling depth of 3/8 in. (10 mm) or damage could
occur to the enclosure wall of the speaker.
q
9 Using the Front Fan Template
Console Bin Front
q
Wall
1. Tape the front fan template to the inside, front wall of
the console bin.
2. Using a marker, trace the center point opening from
the template onto the console bin wall.
e
10 Drilling the Front Fan Opening
3.5 in. (89 mm) Hole
q
3/8 in. (10 mm)
w
Maximum Drilling Depth
10
sound system, do not
®
w
Front Fan Template
w
q
w
3.5 in. (89 mm)
e
Hole Saw Drill Bit
3. Remove the front fan template.
4. Use the 3.5 in. (89 mm) hole saw drill bit to drill an
opening for the front fan.
I Depending on the drill size and type, a right-
angle drill may be required to drill the hole
without damaging the enclosure.
5. Vacuum any debris from the console and console bin
area.
6 .7 Preparing the Rear Power
Connector Location
q
11 Drilling the Rear Power Connector Opening
Equal Width
q
Hole Location for
w
the 12 V Rear Power
Connector
1. On the rear passenger side of the console, identify
the hole location for the 12 V rear power connector
using one of the following methods:
– Insert the provided template downwards behind
the black bracket until it stops.
– Measure 2 in. (50 mm) above the black bracket
and center the hole horizontally.
2. Using a marker, trace the center of the drill hole

location.

GMT1XXCCFT Refrigerator
q
w
e
r
2 in. (50 mm)
e
Black Bracket
r
EN