Installation; Installing The Refrigerator - Dometic CCF-T/GM-T1 Serie Manual De Instalación Y Funcionamiento

GMT1XXCCFT Refrigerator
3. Use the 1 1/8 in. (29 mm) hole saw drill bit to drill an
opening for the 12 V rear power connector.
4. Vacuum any debris from the console and console bin
area.
5. Place the refrigerator near the center console
opening.
6. Insert the end of the refrigerator's 12 VDC power cord
plug into the 1 1/8 in. (29 mm) hole until it snaps into
place.
12 Installing the 12 V Rear Power Connector
12 V Rear Power Connector
q
7. Push the gray 12 VDC rear power connector (that
was disconnected from the console back panel in
"Removing the Console Back Panel" on page 8)
into the refrigerator's 12 VDC power cord plug.
EN
q

7 Installation


WARNING: FIRE HAZARD . Failure to obey
this warning could result in death or serious
injury .
Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of
obstruction.
NOTICE: Do not leave the refrigerator unit in an
inverted position or run the compressor soon after
having the refrigerator in an inverted position. Otherwise
damage to the compressor could occur.
NOTICE: Avoid pinching, crushing, or breaking
the wires or power cord. Otherwise damage to the
refrigerator unit could occur.
This section describes how to install the refrigerator unit
and to reinstall the console back panel and cupholders.

7 .1 Installing the Refrigerator

13 Installing the Refrigerator
Refrigerator Lid
q
Screws
w
1. Lower the refrigerator unit into the console.
2. Open the refrigerator lid.
3. Using a #2 Phillips screwdriver, hand tighten the
provided screws to secure the refrigerator unit to the
mounting brackets.
Installation
q
w
e
Refrigerator Unit
e
11