Kohler Veil K-5402-0 Instrucciones De Instalación página 4

1. Mark the Pipes - Bowl Side
Inlet Pipe
Gasket
Outlet Pipe
Gasket
IMPORTANT! If silicone plumbers grease is not applied to the gaskets, they will bind during fitting, which will result in
the pipes being cut to incorrect lengths.
NOTE: This procedure is easier with the bowl upside down.
Remove the side panels from the bowl and set aside.
Install the gasket on the ribbed end of the inlet pipe.
NOTE: The outlet pipe gasket comes positioned on the thin portion of the outlet pipe. Remove the gasket and reinstall it
as shown.
Install the outlet pipe gasket on the flared end of the outlet pipe.
Apply silicone plumbers grease to the outlet pipe gasket.
Firmly fit the outlet pipe and gasket over the bowl outlet, pushing until it contacts the bowl.
Position a level or other straight edge across the back of the bowl.
Mark the outlet pipe at the back edge of the bowl using the level as a guide.
Apply silicone plumbers grease to the outside of the inlet pipe gasket.
Firmly insert the gasket end of the inlet pipe into the water inlet, pushing until it contacts the bowl.
Position a level or other straight edge across the back of the bowl.
Mark the inlet pipe at the back edge of the bowl using the level as a guide.
Remove the inlet and outlet pipes.
1247364-2-C
Straight Edge
or Level
Outlet Pipe
Inlet Pipe
4 Kohler Co.